Nitrogen Generator for laser cutting

Nitrogen Generator for laser cutting Laser cutting with nitrogen is intended for applications where oxidation is not wanted. For example, an oxide layer can cause paint to adhere less strongly on non-alloy steel. If non-alloy steel is painted after cutting, the cutting gas should be nitrogen. Weldable steel components laser cut with oxygen will not pass the bending test. Stainless steel loses its corrosion resistance when cut with oxygen, and aluminum pieces cut with oxygen have an uneven and burred cut surface. When nitrogen is used as the cutting gas, the laser beam melts the material, and the nitrogen blows away the molten material from the cutting groove. Since no exothermic reaction takes place, the cutting speed is much slower than when cutting with oxygen. To ensure a burr-free cut edge, the laser beam must usually be focused on the bottom surface of the plate
Usage Capacity   Purity Material
nitrogen  generator 5-2000Nm3/hour 95%~99.9995% Carbon steel or stainless steel
Delivert time Working Pressure Power Consumption Outlet Dew Point
40days 5~8bar 0.1kw/hour -60ºC~-45ºC

Advantage * Most reliable technology * More advanced and more economical air separation modules. extremely low power consumption * Simple engineering design, Less components = lower maintenance cost * Automated Operation. * Turn-key solution and pre-commissioned. * Skid mounted design, easy installation. * Durable Molecular Sieve and Steel Structures ensures longer life. * We take the one-on-one service mode , one customer--one saler--one engineer for every set of nitrogen generator .
Nitrogen Generator On Site

Nitrogen Generator for laser cutting Related Video: